hi.
just got back to my table after a few months of not using it
trying to cut 16 gauge with 45 amp fine cut consumables . for last minute Christmas presents
the torch is running about 1/2 in high. I think the problem is in material thickness its set 0
here are settings
feed 300 ipm
pierce 0
pierce height 0.15
cut height 0.06
material thickness o
volts 130
air 130
thanks
al
need set up help
-
- 3.5 Star Member
- Posts: 541
- Joined: Sun Feb 10, 2013 3:13 pm
- Location: mich.
need set up help
Arclight 4x4
hypertherm 65
corel x6
mach 3, sheet cam
miller 211 auto set
hypertherm 65
corel x6
mach 3, sheet cam
miller 211 auto set
-
- 3.5 Star Member
- Posts: 541
- Joined: Sun Feb 10, 2013 3:13 pm
- Location: mich.
Re: need set up help
if all else fails read the owners manual
I will reset everything to fine cut chart x ing my fingers.
if its something else please post
thanks
al
I will reset everything to fine cut chart x ing my fingers.
if its something else please post
thanks
al
Arclight 4x4
hypertherm 65
corel x6
mach 3, sheet cam
miller 211 auto set
hypertherm 65
corel x6
mach 3, sheet cam
miller 211 auto set
-
- 3.5 Star Member
- Posts: 541
- Joined: Sun Feb 10, 2013 3:13 pm
- Location: mich.
Re: need set up help
Got it!!!!
Arclight 4x4
hypertherm 65
corel x6
mach 3, sheet cam
miller 211 auto set
hypertherm 65
corel x6
mach 3, sheet cam
miller 211 auto set
-
- 4 Star Member
- Posts: 1402
- Joined: Mon Aug 30, 2010 5:56 am
- Location: Palm Bch Gardens Fl
- Contact:
Re: need set up help
Glad we could help!!!!
1250 hypertherm
4 X 8 Precision Plasma
CandCnC electronics
4 X 8 Precision Plasma
CandCnC electronics
-
- 3.5 Star Member
- Posts: 541
- Joined: Sun Feb 10, 2013 3:13 pm
- Location: mich.
Re: need set up help
THANKS to all you guys for helping everyone . I new what to do.
haven't used the machine in a few months. so I forgot proper set up.
my archlight table and hypertherm 65 cut real nice when set properly
so in fact you did help and you didn't even know it
thanks
al
haven't used the machine in a few months. so I forgot proper set up.
my archlight table and hypertherm 65 cut real nice when set properly
so in fact you did help and you didn't even know it
thanks
al
Arclight 4x4
hypertherm 65
corel x6
mach 3, sheet cam
miller 211 auto set
hypertherm 65
corel x6
mach 3, sheet cam
miller 211 auto set