need set up help

[abmagrum]

hi.
just got back to my table after a few months of not using it

trying to cut 16 gauge with 45 amp fine cut consumables . for last minute Christmas presents
the torch is running about 1/2 in high. I think the problem is in material thickness its set 0
here are settings
feed 300 ipm
pierce 0
pierce height 0.15
cut height 0.06
material thickness o
volts 130
air 130

thanks
al

[abmagrum]

if all else fails read the owners manual

I will reset everything to fine cut chart x ing my fingers.

if its something else please post

thanks
al

[abmagrum]

Got it!!!!

[Largemouthlou]

Glad we could help!!!!

[abmagrum]

THANKS to all you guys for helping everyone . I new what to do.

haven't used the machine in a few months. so I forgot proper set up.

my archlight table and hypertherm 65 cut real nice when set properly

so in fact you did help and you didn't even know it

thanks
al