Just Getting Started

[Largemouthlou]

Just wanted to say hello to everyone, Been lurking for a while and just now starting to build my table..

Have read many good informitive post here and will have ? to start but hope to help in the future!!

Hope everyone has a great, safe weekend

Louis

[AnotherDano]

Welcome LargeMouth,

That moniker sounds familiar. Are you a powder coater?

Dano

[Largemouthlou]

Another familure face!!

Yes, we have talked on PBTP and 365.. Just started that as well

[AnotherDano]

Another familure face!!

Yes, we have talked on PBTP and 365.. Just started that as well

In that case, DOUBLE welcome.
You'll like the folks on this forum. Great people.
It's the cutters version of the P-365 group; The best and most helpful people in the business.

[Streetwerkz]

man, whats going on here a migration?

[Largemouthlou]

Yup, looks like everyone has been moving around

[Eagle Mtn Metal Works]

Hi all Rod from AZ I got my PC table in April and just now getting it put together, and found out today that I have a bad controller box. Go figure. Lots of good stuff on this site. Hope to get to know a lot of you all.

[Largemouthlou]

Welcome aboard Rod... I've had mine for about 3 months as well before getting started on assembly.. sure not looking foward to any problems.. Hope all goes good for ya, lots of info and good people here