Hey everyone,
I did a search for easyscriber for flashcut cnc and couldn't find any info , so through trial and error ( tons of error ) I finally figured out how to use it.
I have attached some photos of the setup and and will type some info as well.
Step 1 is to open up flash cut ( I use Silver cut from machitech ) and go to configuration ( top right , 2 gears beside key )
Step 2 On the left hand side, click Fabrication heads
Step 3 New Fab Head
Step 4 Enter same as screen shots
Hope it works , let me know if it helped
EasyScriber For Flashcut Software
-
- 1 Star Elite Contributing Member
- Posts: 5
- Joined: Fri Jul 28, 2017 8:50 am
- EasyScriber
- 2.5 Star Member
- Posts: 172
- Joined: Thu Dec 13, 2018 2:13 pm
- Contact:
Re: EasyScriber For Flashcut Software
Thanks for posting your setup. Flashcut is not one that we have worked personally with and your setup is appreciated. Glad you have it set up and working, please keep us posted on your success with this.
-
- 1/2 Star Member
- Posts: 2
- Joined: Thu Sep 26, 2024 11:21 pm
Re: EasyScriber For Flashcut Software
Did you figure out how to solid fill letters with the easyscriber?
- EasyScriber
- 2.5 Star Member
- Posts: 172
- Joined: Thu Dec 13, 2018 2:13 pm
- Contact:
Re: EasyScriber For Flashcut Software
We can help you fill your letters. Do you use Inkscape? If not what software do you do your design work in?ejmetalworks wrote: ↑Thu Sep 26, 2024 11:24 pm Did you figure out how to solid fill letters with the easyscriber?
-
- 1/2 Star Member
- Posts: 2
- Joined: Thu Sep 26, 2024 11:21 pm
Re: EasyScriber For Flashcut Software
I did it with Inkscape. Flash cut hasn’t added a hatch fill option yet but hopefully they will soon.
- EasyScriber
- 2.5 Star Member
- Posts: 172
- Joined: Thu Dec 13, 2018 2:13 pm
- Contact:
Re: EasyScriber For Flashcut Software
Great, glad you were able to make it happen.ejmetalworks wrote: ↑Sun Sep 29, 2024 10:58 pm I did it with Inkscape. Flash cut hasn’t added a hatch fill option yet but hopefully they will soon.
-
- 6 Star Elite Contributing Member
- Posts: 9651
- Joined: Thu Sep 21, 2017 5:22 pm
- Location: Tucson, Arizona
- Contact:
Re: EasyScriber For Flashcut Software
ejmetalworks - thanks for sharing this information! I use Inkscape for hatch fill as well. You instructions for setting up the EasyScriber for Flashcut will be much appreciated by other Flashcut users.ejmetalworks wrote: ↑Sun Sep 29, 2024 10:58 pm I did it with Inkscape. Flash cut hasn’t added a hatch fill option yet but hopefully they will soon.
David