Finally got some time to weld one of these suckers up. I know there are a few different designs of these on here, so I thought I'd throw in the design I like best, maybe someone else will like it. It's super simple and you all can probably draw it up yourself, but I thought I'd share it anyways because sharing is caring right?
I didn't want the holes in it since I figure I'd be clamping it to the table anyways. I did want to be able to fit a vice grip in there... hence the slots. It's 1/4"x4"x12"x12", and the center "web" is in the center of the jig, not flush on the flat edge like some.
Enjoy!
(There are two of the center pieces in the drawing because waste is bad)
2.jpg
3.jpg
Screenshot (23).png
12x12x4square.CDR
12x12x4square.DXF
I think I'm the oldest 10 year old boy on the forum...