Easyscriber engrave attachment for Hypertherm torch's
 

DB2505-1205 plasma torch output

Share and learn with other DIY members who have built their own plasma tables and accessories.
Post Reply
Pro-Fab
Posts: 2
Joined: Sun Jan 03, 2016 1:10 am
Contact:

DB2505-1205 plasma torch output

Post by Pro-Fab » Tue Mar 13, 2018 3:57 am

I have come to the point in my build that I am trying to get mach3 to signal the relay to switch on. I have tried using pins 1, 14,16, and 17 to fire the torch relay. I have the output 1 selected with the corresponding pin selected and port 1. I have zero voltage at the relay input terminals when Mach3 says torch is off. When I switch on the torch I am only seeing a 1.5 volt output to the relay. I am using a solid state relay with an input rating of 3-32 volts. Is this a software issue or a hardware issue?

Pro-Fab
Posts: 2
Joined: Sun Jan 03, 2016 1:10 am
Contact:

Re: DB2505-1205 plasma torch output

Post by Pro-Fab » Sun Feb 10, 2019 12:19 pm

Update: The issue was that a solid state relay doesn't work properly for what I was attempting to do. I purchased a 5 volt arduino switching relay on amazon for $5... Problem solved.

Post Reply

Who is online

Users browsing this forum: No registered users and 3 guests