Plasmacam Height
-
- 1 Star Member
- Posts: 14
- Joined: Thu Nov 16, 2017 3:28 pm
Plasmacam Height
What is the physical height to the highest point of the cable holder on a plasma cam? Is there any adjustment to it? Interested in a 4x4 unit but my shop has a low cieling.
- Francisco
- 2.5 Star Elite Contributing Member
- Posts: 177
- Joined: Tue Feb 23, 2010 4:17 pm
Re: Plasmacam Height
About 90" / 2.3 m
There's no adjustment, per se. You could modify the setup to make it a little shorter, I guess, but not much. You may end up with either a) the cables dragging or b) losing some cutting area.
There's no adjustment, per se. You could modify the setup to make it a little shorter, I guess, but not much. You may end up with either a) the cables dragging or b) losing some cutting area.
- rdj357
- 4 Star Elite Contributing Member
- Posts: 1174
- Joined: Sun Mar 11, 2012 4:40 pm
- Location: Tahlequah, OK
- Contact:
Re: Plasmacam Height
I cut mine off about a foot to allow for clearance to my gantry crane. Works fine.
Robert Johnson
----- PlasmaCam 5x10 Table -----
FourNinety Creations & Learn PC, LLC
Plasmacam Goodies! Snap'NCut Mount, AXXON Cards/Cables, Maintenance Items
Learn Plasmacam Workshops
Learn Plasmacam on Facebook
Learn Plasmacam on YouTube
----- PlasmaCam 5x10 Table -----
FourNinety Creations & Learn PC, LLC
Plasmacam Goodies! Snap'NCut Mount, AXXON Cards/Cables, Maintenance Items
Learn Plasmacam Workshops
Learn Plasmacam on Facebook
Learn Plasmacam on YouTube
-
- 1 Star Member
- Posts: 14
- Joined: Thu Nov 16, 2017 3:28 pm
Re: Plasmacam Height
90" really? I'm 1 inch short lol
-
- 3 Star Elite Contributing Member
- Posts: 316
- Joined: Sat Oct 08, 2016 12:26 pm
Re: Plasmacam Height
I drilled new holes and drop it 5 inch,
Works fine
Works fine
plasmacam 4x8 with DHC2 with Design Edge
Hypertherm 65
Hypertherm 65