I watched the "geodesic fire pit" files get a lot of attention and get taken down, so I thought I'd post this file I worked on over the weekend. You can get half of the dome in a 4' x 4' sheet. The bend angles are 138 degrees for the hex to hex parts, and 142.5 degrees for the hex to pent parts. if you start bending at the score lines, essentially the faces will start to match up. As for artwork, you can add anything you like. I marked to top facing edge with a point, so you could know how the pieces will face after being bent. However, the dxf if for a bottom, so it would be the opposite edge for the top. at scale, it should make about a 27" diameter sphere.
FLAT PATTERM.DXF