Oxy-Fuel Cutting Big Plate at Angle

Hereticfab · Post by **Hereticfab** » Thu Jan 06, 2022 5:42 pm

Hey guys,

I have a new job coming in I need to make some angled cuts I haven't tackled before. Here is a few details with drawings. Looking to see if anyone as any good advice on set up and operation for this.

TTB1 - TTB3 rev. 0 Case Pacific - Shultz Building Temp Tieback Details (2022-01-05).pdf

Post by **weldguy** » Fri Jan 07, 2022 2:48 pm

What parts from this pdf are you having to cut?

Hereticfab · Post by **Hereticfab** » Wed Jan 12, 2022 12:36 pm

The 3 different size plates on the second page.

SegoMan DeSigns · Post by **SegoMan DeSigns** » Wed Jan 12, 2022 1:37 pm

Here is a link to a thread started by Sean P, my version of the torch mount has a miter feature:

viewtopic.php?f=103&t=24499&start=25

Here is a miter on some 3/4" plate

IMG_20200922_122925073.jpg

Oxy-Fuel Cutting Big Plate at Angle

Oxy-Fuel Cutting Big Plate at Angle

Re: Oxy-Fuel Cutting Big Plate at Angle

Re: Oxy-Fuel Cutting Big Plate at Angle

Re: Oxy-Fuel Cutting Big Plate at Angle