I am in the process of resizing some slots to fit the material i'm using and just wanted to double check before I go any further. 12 gauge steel measures in at .1046 but when I translate that into my Corel software it comes up as 0.105 is that the correct number?
Thanks
Resizing Slots
-
DARRYL21270
- 3 Star Member
- Posts: 491
- Joined: Fri Jun 05, 2009 7:09 am
- Location: New Jersey
- Contact:
-
Chopper John
- 3 Star Elite Contributing Member
- Posts: 384
- Joined: Mon Aug 24, 2009 10:22 pm
- Location: Crystal Lake, IL
- Contact:
Re: Resizing Slots
Yes it is, it seems Corel just rounded it up to the nearest thousandths. A human hair is on average .004 thick so .0004 is nothing.
Chopper John
Mad City Cycles, Inc.
"Every piece of paper has two good sides... Unless you use magic marker then you're f*cked."
Mad City Cycles, Inc.
"Every piece of paper has two good sides... Unless you use magic marker then you're f*cked."
-
DARRYL21270
- 3 Star Member
- Posts: 491
- Joined: Fri Jun 05, 2009 7:09 am
- Location: New Jersey
- Contact:
Re: Resizing Slots
Thank You very much 
