Got my system and after a few hiccups its up and running. Well sort of.
Had a wee problem with the cnc interface cable.... it wasn't supplied. You need this, so I had to make up one.
No binding issues at present, jogs in high speed etc.
Ran the test line speed file. Voltage file etc. I can only think that with some more fine tuning on my behalf it should be groovy and I shall not have to hand cut templates any more . Yay
Youtube of the system doing a dry run as I have yet to fill the water table
http://www.youtube.com/watch?v=jnOPLtwvlgk
Please let me know if you have any ideas where to put the bloody wires for the motors
Cheers
Larry
NZ
Torchmate Hypertherm Powermax 45 AVHC-no cnc interface cable
- larrycameron44
- 3.5 Star Member
- Posts: 579
- Joined: Sun Oct 31, 2010 4:12 pm
- Location: Auckland New Zealand
Torchmate Hypertherm Powermax 45 AVHC-no cnc interface cable
You currently do not have access to download this file.
To gain download access for DXF, SVG & other files Click Here
- wishiwastorching
- 2.5 Star Member
- Posts: 108
- Joined: Sat Jun 11, 2011 10:14 pm
Re: 2 x 4 Torchmate Hypertherm Powermax 45 AVHC
Welcome to the Torchmate club!!! I too have a 2x4 and Pmax 45. Though I have mine on saw horses at the moment while I build a custom water table big enough to house TM's new 4ft gantry upgrade. I love mine and can't wait for my table. Good luck!!!
- larrycameron44
- 3.5 Star Member
- Posts: 579
- Joined: Sun Oct 31, 2010 4:12 pm
- Location: Auckland New Zealand
Re: 2 x 4 Torchmate Hypertherm Powermax 45 AVHC
Thanks mate, its the bees knees!