Easyscriber engrave attachment for Hypertherm torch's
 

I’m new!!!!

CNC Plasma Cutters are amazing and there is always plenty of knowledge to share and discuss. Use the CNC plasma cutters general forum for this purpose.
Post Reply
Burnking
Posts: 4
Joined: Fri Feb 09, 2018 7:07 pm

I’m new!!!!

Post by Burnking » Tue Apr 10, 2018 12:18 pm

Hello everyone!!!! I’m brand new to this! I picked up my 5X10 Stealthmax plasma table from Arclight about a week ago. I’m not new at running tables. I’m running the hypertherm 85 on single phase.

Soooo.... my first question is, how well does plasma cut copper? Iv cut copper on a laser but never plasma. Looking to cut .040 or .060. Hope to hear back from you! Thanx!!!!

Old Iron
Elite Contributing Member
Elite Contributing Member
Posts: 529
Joined: Wed Nov 26, 2014 5:12 pm

Re: I’m new!!!!

Post by Old Iron » Wed Apr 11, 2018 9:32 am

It cuts it perfectly
Use an aluminum setting on your Hypertherm cut chart.

Post Reply

Return to “CNC Plasma Cutters General Forum”