All is is going well its a 1.2x1.2 table R&P but the issue I am having is working out the connecting the Proma150THC wire up.
I was going to follow one of the Posts on CNC ZONE but for some reason the inputs outputs seem to be conflicting so I am a bit wary of actually following them.
What I have is the following:
Hypertherm PM45 Machine Torch
Gecko G540 & mach3 48v PS
Proma 150 THC
The voltage divider on the PM45 are pin sockets 5(-) & 6(+) these are to be wired to the Proma THC DV(-)(+) inputs, from what I understand?
Start (start plasma input) pin sockets 3 & 4 are to be wired to the G540 but what actual inputs (5&12) do I just wire them straight up or do need to provide power or create a circuit.
Anyone aware of this set-up is this correct I don't what to destroy the G540 or the VD on the PM45
![Shocked :shock:](./images/smilies/icon_eek.gif)
Thanks is advance.