It is currently Thu Oct 18, 2018 2:26 pm

 

Cut Path Setup

Post your questions or tips on Plasmacam software in this topic.
User avatar
yeomansjon
Elite Contributing Member
Elite Contributing Member
Posts: 332
Joined: Fri Oct 05, 2012 1:28 pm
Contact:

Cut Path Setup

Postby yeomansjon » Thu May 22, 2014 12:37 pm

I am using the older Plasmacam DHC design software (not the updated design edge) and I am having an issue where my cut wants to start at the opposite end of a line from where I click to start it. This seems to be a new problem. I get this whether I have 'snap' on or off. So to setup my file, I have to go around selecting the opposite end of all my cuts. It starts correctly with hole conversions, unless I re-link those lines and have to click the cut path all over again in which case it does the same. Anyone know if there was a setting or something I may have bumped by accident? I can't seem to figure out what would cause this. Any help is appreciated. Thank you.
Fast Jonny Custom Design
CNC Plasma Cutting
Plasmacam DHC
Hypertherm Powermax 1000
www.facebook.com/fastjonnycustomdesign

Return to “Plasmacam Software”

Who is online

Users browsing this forum: No registered users and 1 guest

Easyscriber engrave attachment for Hypertherm torch's