Busy setting up the Height Control on my DHC, meeting with reasonable success, but not quite there yet.
Could anyone shed some light for me on the Arc Voltage Scale.
How does one arrive at a denomination to enter as the scale ?
Any assistance would be appreciated.
Plasmacam DHC - Arc Voltage Scale
-
- 2 Star Member
- Posts: 68
- Joined: Tue Jan 28, 2014 3:20 am
- Location: South Africa
-
- 5 Star Elite Contributing Member
- Posts: 3087
- Joined: Mon Jul 20, 2009 11:18 pm
- Location: North Carolina
Re: Plasmacam DHC - Arc Voltage Scale
I strongly suggest posing that question on the PlasmaCam owners group......they can answer that very well. Go to www.plasmacam.com , click on owners forum, use your machine serial number to register.
The DHC system requires that you zero the torch periodically, especially when you change consumables....this assures that it can accurately track at the correct height during steady state cutting. There height control samples the arc voltage at the beginning of each cut, and then locks onto that voltage in order to compensate for minor changes in material height/warpage, etc.
The newer PlasmaCam's with advanced height control (after the DHC) are nice because you can set the software up to auto calibrate the torch before each cut.....eliminating the need for setting the torch offset.
Jim Colt
The DHC system requires that you zero the torch periodically, especially when you change consumables....this assures that it can accurately track at the correct height during steady state cutting. There height control samples the arc voltage at the beginning of each cut, and then locks onto that voltage in order to compensate for minor changes in material height/warpage, etc.
The newer PlasmaCam's with advanced height control (after the DHC) are nice because you can set the software up to auto calibrate the torch before each cut.....eliminating the need for setting the torch offset.
Jim Colt
-
- 2 Star Member
- Posts: 68
- Joined: Tue Jan 28, 2014 3:20 am
- Location: South Africa
Re: Plasmacam DHC - Arc Voltage Scale
Thank You Jim, I will give Plasmacam owners group a try.
- 1MORECUT
- 2.5 Star Elite Contributing Member
- Posts: 176
- Joined: Wed Mar 31, 2010 6:58 pm
Re: Plasmacam DHC - Arc Voltage Scale
Kangy,
Here's a pdf file on how to setup the arc voltage.
John
Here's a pdf file on how to setup the arc voltage.
John
You currently do not have access to download this file.
To gain download access for DXF, SVG & other files Click Here
-
- 2 Star Member
- Posts: 68
- Joined: Tue Jan 28, 2014 3:20 am
- Location: South Africa
Re: Plasmacam DHC - Arc Voltage Scale
Thank You John, much appreciated. ( Going through a hell of a learning curve at the moment )
Regards
Pat
Regards
Pat