how do your setups look? where do you have your plasma cutter and pc located?
the ideal location for the plasma cutter (hypertherm 65) looks to be under the water table; does that work?
![Image](http://i306.photobucket.com/albums/nn255/_ogre/Misc/Plasma/1210131457_zpsd798a3f0.jpg)
_Ogre wrote:our shop just received our new bulltear 4x8 plasma table. i'm in the middle of moving the bridgeport, buffer, drill press, exhaust bender, disk sander and running new power and air for those pieces of equipment.
how do your setups look? where do you have your plasma cutter and pc located?
the ideal location for the plasma cutter (hypertherm 65) looks to be under the water table; does that work?
Sorry for jumping in here, can I ask if using the wall switch/isolator as an alternative to using the rear panel switch is ok?jimcolt wrote:Under the table is fine for the Powermax65. Keep in mind that you need access to the on/off switch on the rear panel.....as it is the reset safety switch after changing consumables.
Jim Colt Hypertherm