So a few months ago i saw a video of a CNC Plasma table self centering on a piece of square tube. There where micro switches on either side of the torch head and the torch would reference both sides of the pipe or square tube and pierce in the center.
Did anyone else see this? Does any one do this? I think it might be an interesting experiment. Can anyone help me find the video?
center finding set up
-
- 2 Star Elite Contributing Member
- Posts: 92
- Joined: Wed Aug 19, 2009 8:30 pm
-
- 4 Star Member
- Posts: 1472
- Joined: Wed Feb 04, 2009 5:35 pm
Re: center finding set up
That was in this thread from Cindy at Trucut CNC http://www.plasmaspider.com/viewtopic.php?f=76&t=9981 but the first post directing to the link is missing so here is a link to a clip from their website.
Murray
http://www.youtube.com/watch?v=rvnLGf1F ... e=youtu.be
Murray
http://www.youtube.com/watch?v=rvnLGf1F ... e=youtu.be