Sheetcam tools all the same
- Diverdude
- 2 Star Member
- Posts: 65
- Joined: Sun Jan 01, 2012 7:54 pm
- Location: Alabama Gulfcoast
Sheetcam tools all the same
Still trying to the lighting strike to the CNC, just about there. Just got THC card and new parallel port put in and did my first cuts in 3 months since the strike. While it was down I brought the PC in the house and hooked it to the Router and run all the updates. Everything looked good till I set up the cuts once it was all hooked up and when I set the cuts up in Sheetcam, all the tools have the same setting listed. When I put them into a cut the setting is there but I cannot edit and save them. Everything else on it works right?