Easyscriber engrave attachment for Hypertherm torch's

Tracker in my future . . .

Tracker Hardware discussion forum
Post Reply
User avatar
Elite Contributing Member
Elite Contributing Member
Posts: 1116
Joined: Mon Dec 26, 2011 11:38 pm
Location: Baton Rouge, LA

Tracker in my future . . .

Post by CNCCAJUN » Sat May 18, 2013 1:44 pm

OK, TRACKER keeps floating to the top . . .

I have read, researched, gawked, studied, made multiple shop visits, national shows, etc.

TRACKER keeps coming to the top of the list for a turnkey machine under $25,000.00.
A 3 year warranty & unlimited tech support is also attractive.

Attention: This post is not met to elicit "negative" comments about TRACKER, nor is it a request for a list of the various features that another machine has that TRACKER does not. I am already aware of all of them and vice versa.

Purpose of post: Looking for anyone that has a TRACKER that would like to share info about it.

1. Do you like the control software?
2. Have you found limitations that have restricted the type of jobs you can do?
3. Does the control system and drive combination yield acceptable results? (clean circles, sharp corners, etc.)
4. Does the supplied 2000 cfm exhaust system remove the smoke?
5. Were upgrades or options available that are not shown on their website?
Smiling Gator Metal Works, LLC
Dynatorch 4X4 XLS
PowerMAX 85
Baton Rouge, Louisiana

Posts: 493
Joined: Fri Jun 05, 2009 7:09 am
Location: New Jersey

Re: Tracker in my future . . .

Post by DARRYL21270 » Sun May 26, 2013 4:27 pm

I bought my Tracker table a few years ago and have nothing but good things to say about it. The customer service is top notch also. When it's time to upgrade to a newer table I know just where to go.

Post Reply