Problem with THC min setting with Mach 3

[East German]

Hello,
I hope you can help me.

I have a old Plasma Table with floating Head for the Machine Torch with switch connector.
I have the THC min setting of 0,000 thats work well.
I'm building a new machine with contact sensor on the shield from the Machine Torch. Works fine.


My problem is I can press all the buttons on the keyboard but get no min -3 in the THC.
Whenn Mach new install is the setting -3

Thanks for the help

Peter from Germany

[East German]

Hallo,


I've found it. One must go to the settings window. Since work minus

Regards Peter