Can someone help with a dog trace?

wishiwastorching · Post by **wishiwastorching** » Fri Jan 11, 2013 1:41 pm

I tried to trace this with my Torchmate software and had no luck. I'm doing quite of bit of trace work now and would like to buy something a bit easier to trace with, suggestions? Anyways i want to cut this out of 14g at about 12x12" ish.
Thanks in advance if you can help. I had invisioned the white areas be open air cut outs.

metalart · Post by **metalart** » Fri Jan 11, 2013 2:26 pm

Here's a start for you to work from. Hope it helps.

wishiwastorching · Post by **wishiwastorching** » Sun Jan 13, 2013 12:33 pm

Thanks Metalart! You saved the day!!!

metalart · Post by **metalart** » Sun Jan 13, 2013 3:44 pm

You're more than welcome! Always glad to be able to help and give back to this forum!

Steelman_55 · Post by **Steelman_55** » Fri Jan 18, 2013 10:41 pm

Thanks Metalart. You done a very nice job on this piece.

Can someone help with a dog trace?

Can someone help with a dog trace?

Re: Can someone help with a dog trace?

Re: Can someone help with a dog trace?

Re: Can someone help with a dog trace?

Re: Can someone help with a dog trace?