Alright, I imported this file into Sheetcam and everything was reversed. The lead ins are on the outside when they should be on the inside, cutting in the wrong direction, etc. It was created in CorelDraw x5. I have tried simply clicking on the "Reverse Cut Direction" but I can't get the lead-ins to change sides.
Any help would be greatly appreciated!
Lead Ins & Start Points
-
- 3 Star Member
- Posts: 470
- Joined: Thu Mar 03, 2011 12:06 am
- Location: Maine
Lead Ins & Start Points
- Attachments
-
- Cocker Spaniel house numbers 1.dxf
- (124.04 KiB) Downloaded 99 times
-
- 4 Star Member
- Posts: 1472
- Joined: Wed Feb 04, 2009 5:35 pm
Re: Lead Ins & Start Points
Charlene,
In Sheetcam go down to Operations, then on Contour Method change offset from outside to inside or visa versa
Murray
In Sheetcam go down to Operations, then on Contour Method change offset from outside to inside or visa versa
Murray
-
- 3 Star Member
- Posts: 470
- Joined: Thu Mar 03, 2011 12:06 am
- Location: Maine
Re: Lead Ins & Start Points
Thanks Mirth, I will give that I try.
- trucks1948
- 3 Star Elite Contributing Member
- Posts: 440
- Joined: Sat Jun 13, 2009 10:00 am
- Location: Friendship,Wi
Re: Lead Ins & Start Points
I also use corel x5 and when i import into sheetcam ever so often it changes the lead ins from inside top out.