mach 3
-
- 1 Star Member
- Posts: 16
- Joined: Thu Jun 02, 2016 8:50 am
mach 3
on my mach 3 control screen you can adjust your voltage. I am stuck on 120 volts if I'm running a g code or not. I shut everything off and back on still stuck. I usually restart the program and it fixes its self but this time it just is stuck on 120 when I try to increase it goes to 121 and goes back to 120 I click down, and it goes 119 then jumps back to 120. ldr motion systems table . 2016
- djreiswig
- 4.5 Star Elite Contributing Member
- Posts: 2052
- Joined: Thu Nov 19, 2015 10:02 pm
- Location: SE Nebraska
Re: mach 3
If it's a candcnc control, you're not communicating with the hub. Try unplugging the hub power for a few seconds. That usually does it for me.
2014 Bulltear (StarLab) 4x8
C&CNC EtherCut
Mach3, SheetCam, Draftsight
Hypertherm PM65
Oxy/Acetylene Flame Torch
Pneumatic Plate Marker, Ohmic, 10 inch Rotary Chuck (in progress)
C&CNC EtherCut
Mach3, SheetCam, Draftsight
Hypertherm PM65
Oxy/Acetylene Flame Torch
Pneumatic Plate Marker, Ohmic, 10 inch Rotary Chuck (in progress)