P-80 Table, let's make one

Information on plasma cutting nozzles, electrodes, and other consumables.
Post Reply
PlasmaDon
2 Star Member
2 Star Member
Posts: 76
Joined: Wed Nov 15, 2023 6:44 pm

P-80 Table, let's make one

Post by PlasmaDon »

I have never found a settings chart for the P-80 torch.
so I have been experimenting, here is a few settings i have found that work pretty good, please add yours too.

Hypertherm max100
1/2" plate, 100 amps 145 volts 15 ipm .080 kerf
1/2" plate, 100 amps 150 volts 10 ipm (hole not as good, outside same as 15 ipm)

I have to find my other samples at the shop, will add them.
weldguy
4.5 Star Elite Contributing Member
4.5 Star Elite Contributing Member
Posts: 2149
Joined: Fri Apr 17, 2009 11:48 am

Re: P-80 Table, let's make one

Post by weldguy »

That's a machine I haven't seen in a while! Very cool, thanks for posting.
jimcolt
5 Star Elite Contributing Member
5 Star Elite Contributing Member
Posts: 3087
Joined: Mon Jul 20, 2009 11:18 pm
Location: North Carolina

Re: P-80 Table, let's make one

Post by jimcolt »

The best cut charts for the P80 torch would be from a Hypertherm Powermax1250 (which is an 80 amp unit). The 1250 was replaced by the Powermax85 about 15 years ago. The P80 torch is a rough copy of the torch that was used on the Powermax1250, and these are "plunger style blowback torches (invented and patented at Hypertherm!, patents expired a couple of years ago). You can download the 1250 manual with all of its cut charts at www.hypertherm.com. Even better......if you can find a used Powermax1250 you can get the newest Replacement torch from Hypertherm and use it on the 1250......it will cut very much like the newer Powermax85/65 with the Duramax torch.
PlasmaDon
2 Star Member
2 Star Member
Posts: 76
Joined: Wed Nov 15, 2023 6:44 pm

Re: P-80 Table, let's make one

Post by PlasmaDon »

Jim,
Thank you for the reply, but the p-80 is a HF start torch.
Still use the charts from the powermax 1250 ?
PlasmaDon
2 Star Member
2 Star Member
Posts: 76
Joined: Wed Nov 15, 2023 6:44 pm

Re: P-80 Table, let's make one

Post by PlasmaDon »

Update 1/4" mild steel
145 volts 40-45 IPM
PlasmaDon
2 Star Member
2 Star Member
Posts: 76
Joined: Wed Nov 15, 2023 6:44 pm

Re: P-80 Table, let's make one

Post by PlasmaDon »

Update:
Aluminum .090 thick
60 amps
1.3 mm tip
.035 kerf
127 volts
35 IPM
Post Reply

Return to “Plasma Consumables”