My plasma table setup. FastCut Icon with a few trick mods
My setup
- sincityairfx
- 1 Star Member
- Posts: 18
- Joined: Mon Mar 25, 2024 5:45 pm
- Location: Las Vegas, NV
- Contact:
-
- 3 Star Member
- Posts: 294
- Joined: Thu Jul 19, 2012 3:36 am
Re: My setup
Wow, that's a bad ass looking setup. Wanna keep that bad boy clean!!!!
- tinspark
- 3.5 Star Elite Contributing Member
- Posts: 695
- Joined: Wed May 30, 2018 4:28 pm
Re: My setup
Never seen LED’s under a table before. Definitely adds some bling!
Doug,
4x4 GoTorch- expanded
Height Control/Advanced DesignEdge
Hypertherm 45XP-
Logan Lathe + myriads of other shop toys
**CAUTION**- "Does Not Play Well With Others"
4x4 GoTorch- expanded
Height Control/Advanced DesignEdge
Hypertherm 45XP-
Logan Lathe + myriads of other shop toys
**CAUTION**- "Does Not Play Well With Others"
- SegoMan DeSigns
- 4 Star Member
- Posts: 934
- Joined: Sat Jan 06, 2018 4:45 pm
Re: My setup
Nice set-up did you make the chairs?
- sincityairfx
- 1 Star Member
- Posts: 18
- Joined: Mon Mar 25, 2024 5:45 pm
- Location: Las Vegas, NV
- Contact:
Re: My setup
Thank you, the Seats Are from Iron Ace Bomber Seats