Why you cannot just bolt rail or gear rack to tubes

Star-Lab plasma table discussion forum
Post Reply
BTA Plasma
3.5 Star Elite Contributing Member
3.5 Star Elite Contributing Member
Posts: 601
Joined: Thu May 12, 2011 4:28 pm

Why you cannot just bolt rail or gear rack to tubes

Post by BTA Plasma »

Here is a good example of cleaning up a frame on a CNC machine. The first pass will often show the lack of parallelism of the tubes. If you want a SUPERB CNC this is a requirement. Parts made on a modern Star Lab under an optical comparator have proven that Star Lab CNC's have knocked it out of the park.

Image
weldguy
4.5 Star Elite Contributing Member
4.5 Star Elite Contributing Member
Posts: 2149
Joined: Fri Apr 17, 2009 11:48 am

Re: Why you cannot just bolt rail or gear rack to tubes

Post by weldguy »

A picture says a thousand words. Impressive that you machine the table sides true before installing the rails. i think most would like to do that but don’t have the equipment to do it.
User avatar
SegoMan DeSigns
4 Star Member
4 Star Member
Posts: 934
Joined: Sat Jan 06, 2018 4:45 pm

Re: Why you cannot just bolt rail or gear rack to tubes

Post by SegoMan DeSigns »

A video on the truing of the milling machine rails would be fun to watch.
Fastyankee
2 Star Member
2 Star Member
Posts: 72
Joined: Sat May 20, 2017 11:30 am
Location: Fernandina Florida
Contact:

Re: Why you cannot just bolt rail or gear rack to tubes

Post by Fastyankee »

If you can get the machine to work and not crash .
Thanks
AJ
irondeuces@gmail.com
Pulmax
5x10 Star Lab plasma, scribe, pipe cutter
60 ton 53” press brake
JD2 tube bender
Hulk Tube bender
Slip roll 3/16th capacity
Ink Scape
Sheet Cam
Enroute6 user
BTA Plasma
3.5 Star Elite Contributing Member
3.5 Star Elite Contributing Member
Posts: 601
Joined: Thu May 12, 2011 4:28 pm

Re: Why you cannot just bolt rail or gear rack to tubes

Post by BTA Plasma »

If you are experiencing any crash on torch issues there is a guide in the training files section on your desktop that will run through all the possible issues and all the fixes.
Post Reply

Return to “Star-Lab CNC Forum”