Desk Name Plate

[larrycameron44]

Well after a few cuts in the mirror image, it was discovered my motors were going the wrong way. All my fault though. So here is my first official cut on my Torchmate 2 x 4 Water Table Hypertherm Powermax 45 and AVHC with the motors going the right way.
1.9mm thick galvanised plate 100ipm. No dross!!!!!
I have to say, I thought this would be a gigantic learning curve and that I would find it difficult to draw in Torchmate Cad but the webinars make life so much easier watching how its done. I assumed that using the machine would be a major hurdle but everything is pretty much easy. Ok, so I will have some fine tuning to do but if I can cut this piece then it can only get better.
Thank you to all the peoples who have uploaded files, I shall happily contribute as I progress along the plasma pathway!

Cheers everyone.


Larry
NZ

[jmsrbrt]

The rose was a very nice touch.

[Eagle Mtn Metal Works]

The hart definitely looks good. I have used it on many of my peaces. I don't remember who posted the original file but this file is one of my wife's favorite ones.

[stdave66]

I donated the Heart-Rose file around Valentines day, you might remember the "Happy VD!
Anyway, glad to see some have used it!

[Eagle Mtn Metal Works]

Thanks stdave66
I have used it on several files, and my wife just loves it. Thank you for sharing it.