Rocket stove DXF design for plasma

[adbuch]

http://www.desertfabworks.com/

Desert Fabworks LLC image.jpg

[DesertFabworks]

That piece gets bent on the lines and slides in the wood shute 45 to allow an air gap and prevent fuel from blocking flow path. Not sure what an OP is but if that person is talking about me I'm active on here daily

[djreiswig]

OP = original poster

[adbuch]

That piece gets bent on the lines and slides in the wood shute 45 to allow an air gap and prevent fuel from blocking flow path. Not sure what an OP is but if that person is talking about me I'm active on here daily

Glad to hear you are still active. Your last post was on March 6, 2019 so we didn't know if you were/are active still or not.
"OP" stands for Original Poster. Good to hear that all is well.
David

search.php?author_id=7803&sr=posts

Desert Fabworks Last Post.jpg

[DesertFabworks]

Your data is wrong

[adbuch]

Your data is wrong

You can click on the "Post:" xxx number below your name at the upper right hand corner of any of your posts. Try it and you can see a historical record of all of your posts. These can be new topics you started of your replies to existing threads. You have posted 3 times today, and your last previous post was in 2019.

This doesn't include threads you have viewed, only the ones you have commented (posted) in.

David

Posts.jpg

Posts 2.jpg

[djreiswig]

That's what I'm seeing also.

[adbuch]

That's what I'm seeing also.

Perhaps he has more than one account, in which case we would need to know the user name for that account to see posts associated with it.
David

[Rbean]

That piece gets bent on the lines and slides in the wood shute 45 to allow an air gap and prevent fuel from blocking flow path. Not sure what an OP is but if that person is talking about me I'm active on here daily

I see That makes Sense. Thank you very much

[DesertFabworks]

Good to hear

[adbuch]

Thanks for responding.
David

[mm10000]

Hi many thanks for dxf

Can anyone say what this piece is for thanks

[mm10000]

Thanks anyone a pic of it finished ? On the stove

[DesertFabworks]

You can see pictures of the stove here https://www.cncplasmainfo.com/dxffiles.html

[mm10000]

Also what size is the cut on the upright 4 x 4 tube to allow the 45 to join in

[DesertFabworks]

Any size you want

[tinspark]

Also what size is the cut on the upright 4 x 4 tube to allow the 45 to join in

If I am understanding correctly you are asking about the tube cut..
If you are using a 4x4 tube, your cut would also be 4" in order to achieve a 45 deg. angle on a 4" tube.
A 6x6 tube would be a 6" cut etc..
You can use a tri-square to verify the notch.
If you want a different tube takeoff angle, this will not work and will need to either lay out or trigged..

[rubyred]

thank you for the share do you have and thoughts on venting the grate supports in case you use a large pan. i thought about raising the grate but like the flush fit of the cooking surface