Few pits

bhamer62 · Post by **bhamer62** » Thu Jun 10, 2021 11:40 am

It's that time to make a few pits...... 30" square bottom plate, 1/4" thick; 42" Sq

top opening, 7 ga.

Post by **plasmanewbie** » Thu Jun 10, 2021 12:48 pm

Fantastic looking pits and pics! Well done

Post by **LakeCruiser** » Thu Jun 10, 2021 1:11 pm

Nice!

Post by **adbuch** » Fri Jun 11, 2021 3:19 am

Very nice! I'm glad to see you are using heavy material to help prevent any warping during use.
David

bhamer62 · Post by **bhamer62** » Fri Jun 11, 2021 9:14 am

Thanks!! There's a few spots I shoulda beefed up on the bear sides but they will hold up on these.....

Post by **tinspark** » Fri Jun 11, 2021 5:36 pm

bhamer62 wrote: ↑Fri Jun 11, 2021 9:14 am Thanks!! There's a few spots I shoulda beefed up on the bear sides but they will hold up on these.....

Have them keep the coal bed away from that sides and it should b fine..
Nice job on the fit and finish...

Post by **BAR M** » Fri Jun 11, 2021 10:47 pm

WOW! Those are awesome