All kinds of FUBAR going on. New Guy needs help

Inkscape related questions, tips and topics can be posted here
Post Reply
mkingaz
2 Star Member
2 Star Member
Posts: 58
Joined: Wed Jun 05, 2019 7:32 pm
Location: Glendale Arizona

All kinds of FUBAR going on. New Guy needs help

Post by mkingaz »

Hi everyone,

I have been trying to build this project for about 2 weeks now and just cannot get it drawn up correctly to save my life. Figured it might be time to ask for help. I was trying to union the entire piece and then tried to cut the center out and I was going to layer it on top of plexi-glass and glue it back into place. It would be night to keep it all as one if possible. I was doing a duplicate backing sheet with it.

Can anyone help be get this correct?
MIKEJODYCIRCLE.dxf
custom piece I was trying to make
(310.9 KiB) Downloaded 49 times
User avatar
acourtjester
6 Star Elite Contributing Member
6 Star Elite Contributing Member
Posts: 7770
Joined: Sat Jun 02, 2012 6:04 pm
Location: Pensacola, Fla

Re: All kinds of FUBAR going on. New Guy needs help

Post by acourtjester »

I looked it over and you have hundreds of short lines and curves that is not way you can do what you want with this drawing.
I would suggest you contact Ben Delap to have him draw a new file.
www.etsy.com/shop/DesignsByDeLap https://www.facebook.com/designs.by.delap
partsAAA.JPG
DIY 4X4 Plasma/Router Table
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PowerTig 255 EXT
ctgolfer1
2 Star Member
2 Star Member
Posts: 86
Joined: Thu May 30, 2019 4:35 pm

Re: All kinds of FUBAR going on. New Guy needs help

Post by ctgolfer1 »

mkingaz wrote: Tue Oct 01, 2019 7:23 pm Hi everyone,

I have been trying to build this project for about 2 weeks now and just cannot get it drawn up correctly to save my life. Figured it might be time to ask for help. I was trying to union the entire piece and then tried to cut the center out and I was going to layer it on top of plexi-glass and glue it back into place. It would be night to keep it all as one if possible. I was doing a duplicate backing sheet with it.

Can anyone help be get this correct?MIKEJODYCIRCLE.dxf
Hey man, I have to totally agree with the above poster, there is way too much going on in there to cut it on plasma, Ben Delap will clean that up and return it to you in a clean file that can be cut. Ben has done a some work for me and it most likely the only way your going to get this cut, he does not charge very much.
Good luck!
mkingaz
2 Star Member
2 Star Member
Posts: 58
Joined: Wed Jun 05, 2019 7:32 pm
Location: Glendale Arizona

Re: All kinds of FUBAR going on. New Guy needs help

Post by mkingaz »

Thank you both for the input. Much appreciated.
Post Reply

Return to “Inkscape”