Hello everyone!!!! I’m brand new to this! I picked up my 5X10 Stealthmax plasma table from Arclight about a week ago. I’m not new at running tables. I’m running the hypertherm 85 on single phase.
Soooo.... my first question is, how well does plasma cut copper? Iv cut copper on a laser but never plasma. Looking to cut .040 or .060. Hope to hear back from you! Thanx!!!!
I’m new!!!!
-
- 3.5 Star Member
- Posts: 681
- Joined: Wed Nov 26, 2014 5:12 pm
Re: I’m new!!!!
It cuts it perfectly
Use an aluminum setting on your Hypertherm cut chart.
Use an aluminum setting on your Hypertherm cut chart.