Help finding oem consumables

Cut quality issues can be discussed here, most common issues have been discussed here and should help you.
Post Reply
Dooggins1
1 Star Member
1 Star Member
Posts: 13
Joined: Sun Jul 23, 2017 9:16 pm

Help finding oem consumables

Post by Dooggins1 »

Whats up! I have an everlast 60s plasma and looking for oem type consumables for fine cut type stuff. i have searched the net and everlast website to no previail. Any help would be appreciated.
tcaudle
4 Star Elite Contributing Member
4 Star Elite Contributing Member
Posts: 1353
Joined: Tue Feb 28, 2012 6:47 pm

Re: Help finding oem consumables

Post by tcaudle »

Tecmo makes the torch and consumables .
http://www.tecmo.it/upld/repository/File/02.PT+TH.pdf

There are no "fine cut " consumables for that torch .

Good luck on finding the actual parts listed somewhere for you to buy.
Dooggins1
1 Star Member
1 Star Member
Posts: 13
Joined: Sun Jul 23, 2017 9:16 pm

Re: Help finding oem consumables

Post by Dooggins1 »

what i meant was a 10-20 amp tip. Im cutting thin stuff and would like a smaller arc (terminology)
tcaudle
4 Star Elite Contributing Member
4 Star Elite Contributing Member
Posts: 1353
Joined: Tue Feb 28, 2012 6:47 pm

Re: Help finding oem consumables

Post by tcaudle »

Then you are SOL. They don't make fine cut or low current tips for that torch .
Since that OEM manufacturer of your torch is one of the largest after market consumables providers too, you can rest assured that no one else would make it
I don't know the feasibility to mount one of the smaller torches on the 60s.
Brand X
3.5 Star Member
3.5 Star Member
Posts: 511
Joined: Wed Apr 23, 2014 2:48 pm

Re: Help finding oem consumables

Post by Brand X »

Looks like they make the tip you want for your PT-60 torch
Tip, Contact Cutting, ø 0.65, 10-20A, Back Striking 51318.06
tcaudle
4 Star Elite Contributing Member
4 Star Elite Contributing Member
Posts: 1353
Joined: Tue Feb 28, 2012 6:47 pm

Re: Help finding oem consumables

Post by tcaudle »

contact cutting ? what does that mean? It appears its designed as a drag tip. dunno what the "flat tip" version is.
Brand X
3.5 Star Member
3.5 Star Member
Posts: 511
Joined: Wed Apr 23, 2014 2:48 pm

Re: Help finding oem consumables

Post by Brand X »

If you look at the machine torch, it shows the same setup. Don't think drag only tip Just need to find one and give it a go.. One thing is a tip might not be perfect for standoff cutting, but sure beats changing a torch out.. Nothing to loose, and everything to gain..
Post Reply

Return to “Plasma Cut Quality Forum”