3.1 and windows 10

RPM · Post by **RPM** » Sat Aug 19, 2017 5:22 pm

Can 3.1 software run on Windows 10, not quite ready for Design Edge

Post by **1MORECUT** » Tue Aug 29, 2017 8:12 pm

I been told it will work on windows 7 and older.

John

Rick Adams · Post by **Rick Adams** » Mon Jan 21, 2019 5:47 pm

I installed 3.11 on my windows 10 computer, Windows 10 would not recognize the PC software. After some research i learned that AXXON Softio sells a PCI port that was developed for Plasmacam, its the LF1119KB PCI card. I ordered the card from Amazon and it arrived 3 days later, installed the card and the PC software showed up instantly. after some emailing back and forth with AXXONs tech support a couple of times to get configuration values set just right i was able to get the machine and my computer to talk to each other. Can't say enough about AXXON their customer support is awesome.

Rick

Post by **rdj357** » Tue Jan 22, 2019 8:56 am

That's great info Rick! I have 3.11 on a Windows 10 computer but it is not the one that I control the table with so I had no personal knowledge of its ability to work with the parallel port part of things.

Post by **Metaspec** » Fri Jul 05, 2019 10:16 pm

windows 10 will work fine with the axon card or the 20.00 amazon card

3.1 and windows 10

3.1 and windows 10

Re: 3.1 and windows 10

Re: 3.1 and windows 10

Re: 3.1 and windows 10

Re: 3.1 and windows 10