Scrap metal's about used up. This one's approx. 32" long by 15" tall. Powdercoated. File is from MakeCNC.
Allen
DRAGON
- acourtjester
- 6 Star Elite Contributing Member
- Posts: 7869
- Joined: Sat Jun 02, 2012 6:04 pm
- Location: Pensacola, Fla
Re: DRAGON
Looks great happy you found where all the parts went
DIY 4X4 Plasma/Router Table
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PowerTig 255 EXT
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PowerTig 255 EXT
- Craig
- 3.5 Star Member
- Posts: 628
- Joined: Mon Dec 24, 2012 3:43 pm
- little blue choo
- 4 Star Member
- Posts: 1460
- Joined: Mon Mar 02, 2015 10:38 pm
- Location: Cherryville NC
- Contact:
Re: DRAGON
Very nice!
Rick
Rick
Rick
Arclight 9600 4x8 table
Hypertherm PM65
Acc. Plate Marker, 4 inch Pipe Cutter, Wood Router package
Quincy Q54 compressor 2 stage, 5hp, 60 gal
Refrigerated air dryer & 4 stage filtration system
Software Mach 3, Sheetcam, Solid Edge 2D, Inkscape
Arclight 9600 4x8 table
Hypertherm PM65
Acc. Plate Marker, 4 inch Pipe Cutter, Wood Router package
Quincy Q54 compressor 2 stage, 5hp, 60 gal
Refrigerated air dryer & 4 stage filtration system
Software Mach 3, Sheetcam, Solid Edge 2D, Inkscape
-
- 2.5 Star Member
- Posts: 109
- Joined: Sun Mar 27, 2011 8:14 pm
- Location: on canada
Re: DRAGON
My take on the dragon that someone posted on here a while ago. Haven't decided if I'm adding the wings yet or not. Approx 9 feet long and 3 feet high and around 700 lbs.
Thanks Mark
Thanks Mark
- MetalheadRK
- 3 Star Member
- Posts: 300
- Joined: Fri Mar 23, 2012 4:44 pm
Re: DRAGON
Do the wings!! I would love to see it. AWESOME!!
4x4 PlasmaCam
Hypertherm 45
Eastwood 175 MIG welder
Hypertherm 45
Eastwood 175 MIG welder