Easyscriber engrave attachment for Hypertherm torch's
 

"Unable to open port to plasma unit"

Dynatorch hardware discussion forum
Post Reply
Demarkles
Posts: 1
Joined: Fri Sep 23, 2016 7:51 pm

"Unable to open port to plasma unit"

Post by Demarkles » Tue Nov 15, 2016 12:10 am

I'm trying to make my first cut but am getting this message. For whatever reason my thermal dynamics A80 isn't connecting to the table. I have the box checked for "Automatically connect at startup" but it doesn't connect and when I try to test the ports it gives the message: "This manufacturer is not currently supported." even though TD is one of the manufacturers you can select.

Post Reply