Easyscriber engrave attachment for Hypertherm torch's
 

File Convert to Cut Path Error

If you are looking for help with a file conversion please post it here rather than in the file sharing forums.
Post Reply
HeritageSignCo
Posts: 6
Joined: Sat Oct 06, 2018 6:16 pm

File Convert to Cut Path Error

Post by HeritageSignCo » Sat Oct 06, 2018 6:20 pm

Hello,

Could someone assist in what is wrong with the convert to cut path error. I am trying to get this ready to cut on PlasmaCam v 2.12 and keep getting an error. File in attachements.

You do not have access to download this dxf file.
Become a Contributing Member to gain access to the thousands of files shared by our members. Click Here


harrymorley
Elite Contributing Member
Elite Contributing Member
Posts: 671
Joined: Thu Nov 21, 2013 5:32 pm

Re: File Convert to Cut Path Error

Post by harrymorley » Fri Nov 02, 2018 4:53 pm

here ya go..check the width of the bridging / stencil cut..might have to be wider

You do not have access to download this dxf file.
Become a Contributing Member to gain access to the thousands of files shared by our members. Click Here


Post Reply

Return to “File Conversion Help Wanted”