Easyscriber engrave attachment for Hypertherm torch's
 

help with cutable file

If you are looking for help with a file conversion please post it here rather than in the file sharing forums.
Post Reply
PERDMIER
Posts: 3
Joined: Fri Oct 05, 2018 6:14 pm

help with cutable file

Post by PERDMIER » Fri Oct 05, 2018 11:22 pm

Hi, I am needing a little help creating a DXF file for a gift... any help is great full!
recla-motorcycle.png

You do not have access to download this dxf file.
Become a Contributing Member to gain access to the thousands of files shared by our members. Click Here


Old Iron
Elite Contributing Member
Elite Contributing Member
Posts: 492
Joined: Wed Nov 26, 2014 5:12 pm

Re: help with cutable file

Post by Old Iron » Sat Oct 06, 2018 11:22 pm

You could at least introduce yourself :roll:

You do not have access to download this dxf file.
Become a Contributing Member to gain access to the thousands of files shared by our members. Click Here


User avatar
little blue choo
Elite Contributing Member
Elite Contributing Member
Posts: 1457
Joined: Mon Mar 02, 2015 10:38 pm
Location: Cherryville NC
Contact:

Re: help with cutable file

Post by little blue choo » Sun Oct 07, 2018 3:36 pm

YEA I know. First post is asking for someone to create a file for a GIFT and they're not even a contributing member.

Rick
Rick
Arclight 9600 4x8 table
Hypertherm PM65
Acc. Plate Marker, 4 inch Pipe Cutter, Wood Router package
Quincy Q54 compressor 2 stage, 5hp, 60 gal
Refrigerated air dryer & 4 stage filtration system
Software Mach 3, Sheetcam, Solid Edge 2D, Inkscape

PERDMIER
Posts: 3
Joined: Fri Oct 05, 2018 6:14 pm

Re: help with cutable file

Post by PERDMIER » Thu Nov 15, 2018 4:29 pm

Old Iron wrote:You could at least introduce yourself :roll:
thanks, and sorry for no introduction..

PERDMIER
Posts: 3
Joined: Fri Oct 05, 2018 6:14 pm

Re: help with cutable file

Post by PERDMIER » Thu Nov 15, 2018 4:31 pm

little blue choo wrote:YEA I know. First post is asking for someone to create a file for a GIFT and they're not even a contributing member.

Rick
contributing member, DONE. sorry i did not meet your expectations....

djreiswig
Elite Contributing Member
Elite Contributing Member
Posts: 405
Joined: Thu Nov 19, 2015 10:02 pm

Re: help with cutable file

Post by djreiswig » Thu Nov 15, 2018 10:23 pm

Welcome to the forum.
2014 Bulltear (StarLab) 4x8
C&CNC EtherCut
Mach3, SheetCam, Draftsight
Hypertherm PM65
Oxy/Acetylene Flame Torch
Pneumatic Plate Marker, Ohmic, 10 inch Rotary Chuck (in progress)

Post Reply