Can someone help me out by tracing these logos? I mainly only care about the one in the upper left corner. Since they were drawn with pencil when I try and trace it it traces all the brush strokes also.
Thanks
Michael
Help with a trace
-
- 2 Star Member
- Posts: 72
- Joined: Wed Feb 05, 2014 5:17 pm
- Location: Dallas Texas
Help with a trace
You currently do not have access to download this file.
To gain download access for DXF, SVG & other files Click Here
- rdj357
- 4 Star Elite Contributing Member
- Posts: 1174
- Joined: Sun Mar 11, 2012 4:40 pm
- Location: Tahlequah, OK
- Contact:
Re: Help with a trace
Here you go, not cut ready at all but is a reasonable start!
Hope it helps.
Hope it helps.
You currently do not have access to download this file.
To gain download access for DXF, SVG & other files Click Here
Robert Johnson
----- PlasmaCam 5x10 Table -----
FourNinety Creations & Learn PC, LLC
Plasmacam Goodies! Snap'NCut Mount, AXXON Cards/Cables, Maintenance Items
Learn Plasmacam Workshops
Learn Plasmacam on Facebook
Learn Plasmacam on YouTube
----- PlasmaCam 5x10 Table -----
FourNinety Creations & Learn PC, LLC
Plasmacam Goodies! Snap'NCut Mount, AXXON Cards/Cables, Maintenance Items
Learn Plasmacam Workshops
Learn Plasmacam on Facebook
Learn Plasmacam on YouTube
-
- 2 Star Member
- Posts: 72
- Joined: Wed Feb 05, 2014 5:17 pm
- Location: Dallas Texas
Re: Help with a trace
Robert
Thank you very much this is a great start. When I traced it it was a million tiny jumbled lines and none of them joined.
Thanks
Michael
Thank you very much this is a great start. When I traced it it was a million tiny jumbled lines and none of them joined.
Thanks
Michael