It is currently Wed Nov 14, 2018 9:12 pm

 

Help with a trace

If you are looking for help with a file conversion please post it here rather than in the file sharing forums.
MGardner
Posts: 72
Joined: Wed Feb 05, 2014 5:17 pm
Location: Dallas Texas

Help with a trace

Postby MGardner » Sun Sep 16, 2018 8:03 pm

Can someone help me out by tracing these logos? I mainly only care about the one in the upper left corner. Since they were drawn with pencil when I try and trace it it traces all the brush strokes also.
Thanks
Michael

You do not have access to download this dxf file.
Become a Contributing Member to gain access to the thousands of files shared by our members. Click Here


User avatar
rdj357
Elite Contributing Member
Elite Contributing Member
Posts: 539
Joined: Sun Mar 11, 2012 4:40 pm

Re: Help with a trace

Postby rdj357 » Mon Sep 17, 2018 7:11 am

Here you go, not cut ready at all but is a reasonable start!

Hope it helps.

GV.jpg

You do not have access to download this dxf file.
Become a Contributing Member to gain access to the thousands of files shared by our members. Click Here

Robert Johnson
----- PlasmaCam 5x10 Table -----
FourNinety Creations & Learn PC, LLC

Learn Plasmacam Website
Learn Plasmacam on Facebook
Learn Plasmacam on YouTube

MGardner
Posts: 72
Joined: Wed Feb 05, 2014 5:17 pm
Location: Dallas Texas

Re: Help with a trace

Postby MGardner » Mon Sep 17, 2018 9:35 am

Robert
Thank you very much this is a great start. When I traced it it was a million tiny jumbled lines and none of them joined.
Thanks
Michael


Return to “File Conversion Help Wanted”

Who is online

Users browsing this forum: No registered users and 1 guest

Easyscriber engrave attachment for Hypertherm torch's