It is currently Wed Nov 14, 2018 2:02 am

 

File Convert to Cut Path Error

If you are looking for help with a file conversion please post it here rather than in the file sharing forums.
HeritageSignCo
Posts: 3
Joined: Sat Oct 06, 2018 6:16 pm

File Convert to Cut Path Error

Postby HeritageSignCo » Sat Oct 06, 2018 6:20 pm

Hello,

Could someone assist in what is wrong with the convert to cut path error. I am trying to get this ready to cut on PlasmaCam v 2.12 and keep getting an error. File in attachements.

You do not have access to download this dxf file.
Become a Contributing Member to gain access to the thousands of files shared by our members. Click Here


harrymorley
Elite Contributing Member
Elite Contributing Member
Posts: 597
Joined: Thu Nov 21, 2013 5:32 pm

Re: File Convert to Cut Path Error

Postby harrymorley » Fri Nov 02, 2018 4:53 pm

here ya go..check the width of the bridging / stencil cut..might have to be wider

You do not have access to download this dxf file.
Become a Contributing Member to gain access to the thousands of files shared by our members. Click Here



Return to “File Conversion Help Wanted”

Who is online

Users browsing this forum: No registered users and 1 guest

Easyscriber engrave attachment for Hypertherm torch's