Easyscriber engrave attachment for Hypertherm torch's


Post BobCAD related questions and tips in this topic.
Post Reply
Elite Contributing Member
Elite Contributing Member
Posts: 1489
Joined: Tue Feb 22, 2011 5:15 pm
Location: Mountain City, Tennessee


Post by DXF » Wed Mar 21, 2018 11:17 am

If you want to be called again and again after you tell them you don't want their software.....give them your phone #. I almost hung up on them today and will do so if they ever bug me again!

Dave Hanks

Posts: 201
Joined: Mon Jan 13, 2014 10:37 am
Location: Boronia, Melbourne, Australia

Re: Warning.....BobCAD

Post by BensPlasmaAu » Mon Mar 26, 2018 4:37 am

Yep! They sure are hard sell. I have V26 and wanted to upgrade, but they are just sooooo expensive. When I upgrade everything, I’m going to give Fusion 360 a crack. And it’s free for where I am and will be for a little bit anyway.

I do find BobCAD to be pretty easy to use for 2d drawings. I will probably keep using it for some time until my computer dies or I learn Fusion well.
Home built 3400 x 1400mm (11 and a bit X a bit over 4.5 feet)
Hypertherm Powermax 45
CandCNC Bladerunner IV
Some air dryer off the internet
Another water seperator I found unused on a shelf
Refrigerated air dryer

Post Reply

Return to “BobCAD”