Vicon Post processor

BobCAD related questions, tips and topics can be posted here
Post Reply
MidAmericaIron
2 Star Member
2 Star Member
Posts: 59
Joined: Thu Dec 13, 2012 9:37 pm
Location: St. Louis, MO

Vicon Post processor

Post by MidAmericaIron »

Al,
I have version 25. Does BOBCAD/CAM have a post processor for my Vicon table? I have the Vicon 3.4 software. I would rater use your software for my post processor than the Vicon software because their software is designed more for the HVAC industry.
aldepoalo
1 Star Member
1 Star Member
Posts: 17
Joined: Mon Jun 06, 2011 1:05 pm

Re: Vicon Post processor

Post by aldepoalo »

Hello MidAmerican Iron,

I am not sure if we have a Vicon post or not. I would have to check our www.bobcadsupport.com page and look. My assumption is if this machine takes g-code for lines and arc and uses an Mcode for cutter on and off it shouldn't be a problem.

I did a quick search and didn't find the post on our website. That being the case it wouldn't take much to set one up.
Post Reply

Return to “BobCAD”