Easyscriber engrave attachment for Hypertherm torch's
 

Vicon Post processor

Post BobCAD related questions and tips in this topic.
Post Reply
MidAmericaIron
Posts: 59
Joined: Thu Dec 13, 2012 9:37 pm
Location: St. Louis, MO

Vicon Post processor

Post by MidAmericaIron » Tue Oct 20, 2015 9:20 am

Al,
I have version 25. Does BOBCAD/CAM have a post processor for my Vicon table? I have the Vicon 3.4 software. I would rater use your software for my post processor than the Vicon software because their software is designed more for the HVAC industry.

aldepoalo
Posts: 17
Joined: Mon Jun 06, 2011 1:05 pm

Re: Vicon Post processor

Post by aldepoalo » Mon Mar 27, 2017 10:43 am

Hello MidAmerican Iron,

I am not sure if we have a Vicon post or not. I would have to check our www.bobcadsupport.com page and look. My assumption is if this machine takes g-code for lines and arc and uses an Mcode for cutter on and off it shouldn't be a problem.

I did a quick search and didn't find the post on our website. That being the case it wouldn't take much to set one up.

Post Reply