NEW have bobcad and nc editor and baliegh plasma

[Wes11293]

As the description says I have bobcad, nc editor , and baliegh plasma table. I also have a thumb drive that I was trying to use once I build the jobs bobcat then create my NC code from NC editor once saving it to the thumb drive I transfer it to the plasma table and it shows the scale is way off about 1000 more than it does when I’m building it my question is how do I get the scaling right on bobcat for the plasma table I’m new to this I’m just trying to figure it out but I don’t understand how I can build on bobcad get my measurement correct in inches and then when I put it on the machine doesn’t even recognize it because it’s so out of scale

[Larry83301]

Check the settings on your machine, sounds like it's reading in metric and you're creating it in inches. Settings should be in manual for the machine.


Larry