I'm a beginner at this and could use some help. The video manual that came with my plasmacam, said I need to install a relay if I measure more then 45volt at 100ma. at the plug. I measured 6v at 190ma. My current is to high so a relay is needed I'm told. It is working right now, but I worried that it may hurt the plasmacam control unit.
Does anyone have a diagram showing how to wire the relay in? What size relay? 6 volts @ 100am,?
Can anyone help me.
It is currently Wed Nov 14, 2018 10:42 am
Share tips and tricks you know of in this forum. Plasma cutting, material handling, metal finishing, marketing, or anything that you feel is helpful.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 3 guests