Page 1 of 1

Indoor and Outdoor Sign standoff discussion thread

Posted: Wed Aug 09, 2017 11:50 am
by Nacs Fab
I have made a few signs with individual letters for outdoor installation in stucco siding and wonder about installing a sign in sheet rock. Could I use the same principal or do you have any good ideas for attaching small individual letters to a sheet rock surface? I would rather do the pegs like I did on the sign below. Basically I welded 1/4" metal dowels to the back of the sign - 3" long and printed a full size template for general contractor to tape up and drill the holes to install it. They then used a quick set epoxy in the holes and positioned the letters.

Sign Crop.jpg


20604733_500863033586446_6843520270195393183_n.jpg


Give me some ideas you have used to install a standoff sign in sheet rock. Thanks!