What do you guys charge per inch on 3/8 and 1/4 aluminum hot off the table, no finish work, customer supplied material?
I have a job on 3/8 Alum with 101 pierces and 1266" of cut, and 1/4 Alum job with 54 pierces and 749" of cut.
Price check on aluminum
-
- 1 Star Member
- Posts: 21
- Joined: Mon May 16, 2016 3:56 am
Re: Price check on aluminum
bump. Anyone please please?
-
- 2.5 Star Member
- Posts: 101
- Joined: Sun Aug 18, 2013 8:47 pm
Re: Price check on aluminum
Run the job report to see what the total cut time is, and charge by the hour for your table time and any design time
-
- 1.5 Star Member
- Posts: 34
- Joined: Sun Dec 15, 2013 9:22 pm
Re: Price check on aluminum
I would charge 450 for the 3/8 and 175 for the 1/4.
-
- 1.5 Star Member
- Posts: 34
- Joined: Sun Dec 15, 2013 9:22 pm
Re: Price check on aluminum
I just charge inches of cut x material thickness. Normally don't charge for Pierce points unless there isn't much for inches of cut and a ton of Pierces.
-
- 1 Star Member
- Posts: 21
- Joined: Mon May 16, 2016 3:56 am
Re: Price check on aluminum
I dont do alot of side work but when i do i use jim colts simple pricing of double the material cost per inch so i was just wanted to make sure my prices were fair. I was .21 cents on the 3/8 and .13 cents on the 1/4.
Thank you for the replies fellas. Based off bbkf2009's prices i see i am more than fair. It was only about an hr/half worth of cutting on two 3'x4' plates that were easy to manage. Its also for a company i work for. Probably should of included this info.
Thank you for the replies fellas. Based off bbkf2009's prices i see i am more than fair. It was only about an hr/half worth of cutting on two 3'x4' plates that were easy to manage. Its also for a company i work for. Probably should of included this info.