Easyscriber engrave attachment for Hypertherm torch's
 

drag start torch

This forum is for plasma cutting related tools and accessories. Discuss products and tools that have worked or not worked for you.
Post Reply
pishta
Posts: 2
Joined: Fri May 12, 2017 10:56 pm

drag start torch

Post by pishta » Sat May 13, 2017 12:23 am

Can anyone tell me a model number of a drag start/contact start torch that is NOT high frequency start, blow back or pilot start? in the 35A range. All I see in replacement torches are those 3 that I cant use. Must have a switch too. Its for an older Cebora built cutter.

Post Reply