Easyscriber engrave attachment for Hypertherm torch's
 

Connecting Proma150 to a Miller Spectrum 870 and G540 controller

This forum is for plasma cutting related tools and accessories. Discuss products and tools that have worked or not worked for you.
Post Reply
Searchman
Posts: 203
Joined: Tue Aug 18, 2015 11:30 am

Connecting Proma150 to a Miller Spectrum 870 and G540 controller

Post by Searchman » Fri Feb 03, 2017 4:44 pm

I am installing a Proma 150 THC to a Gecko G540 and a Miller Spectrum 875 plasma machine. I would like a wiring diagram for the setup. I am to the point that I need to connect the machine torch cutting tip to a point in the wiring system or does it get connected to a grounding point on the table.

Post Reply