kerf?

Information on plasma cutting nozzles, electrodes, and other consumables.
Post Reply
kbenz
3 Star Elite Contributing Member
3 Star Elite Contributing Member
Posts: 465
Joined: Sun Oct 31, 2010 1:26 pm
Location: Kannapolis,NC
Contact:

kerf?

Post by kbenz »

what should the kerf be set at for fine cut consumables?
kbenz
3 Star Elite Contributing Member
3 Star Elite Contributing Member
Posts: 465
Joined: Sun Oct 31, 2010 1:26 pm
Location: Kannapolis,NC
Contact:

Re: kerf?

Post by kbenz »

on 1/8" material
rottenleonard
1.5 Star Member
1.5 Star Member
Posts: 33
Joined: Sun Nov 20, 2011 10:30 am

Re: kerf?

Post by rottenleonard »

Make a short cut and use digital calipers to measure how wide the cut is then input that measurement as the kerf width.
Hope that helps.
Dawgonhawg
3 Star Member
3 Star Member
Posts: 487
Joined: Sun Mar 27, 2011 10:13 pm

Re: kerf?

Post by Dawgonhawg »

.027 is what I use..

Dawg
Post Reply

Return to “Plasma Consumables”